1473T Repair Tips
Search: 1473T
Results 6
Results 6
| Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
|---|---|---|---|---|---|
| Bush | 1473T | Dead set, Blown BU808DF | Replace the BU808DFI and check or replace C602 in the base feed. The drive appears normal, but the set can be slow to start, the BU will overheat & eventually fail again | ||
| Bush | 1473T | To enter serv mode on "11AK08" version (printed on front edge of chassis) | 1 Press vol- on the keypad 2 Press 'prog' on the handset 3 Press '--' on the handset 4 Press TV on the handset (That's the one with the blank screen on it) Use prog + & - to select parameters and vol + & - to alter values. The red button stores and the exit with 'TV' | ||
| Bush | 1473T 11AK20 | Field collapse | R709 sm 10k adjacent to FOP chip not properly soldered in | ||
| Bush | 1473T 11AK08 | Pic int smeary or dissappears | Dry joint PL901 earth wire on crt base panel | ||
| Bush | 1473T 11AK08 | Line tearing | C818 (47MFD 160VW), +B line smoothing capacitor (high ESR). | ||
| Bush | 1473T | Dead - off with flash | BUZ77B chopper s/c; R805 330k hi res at 570k; R889 0R47 o/c & replaced TDA4605-2 & C831 1ยต 50v as a precaution |